next newest topic | next oldest topic |
Author | Topic: Barrier Undercut Tolerance |
JeffdlS Senior Member Posts: 10 |
posted June 08, 2001 03:53 PM
I was wondering if anyone knows if there are any set tolerances for the undercut of the barrier flight on a screw. Is there something like +/- .005"? I ask because there is nothing that I can readily find in regards to this. Thanks. Jeff de los Santos IP: Logged |
admin2 Member Posts: 15 |
posted June 11, 2001 05:53 AM
Jeff: I typically design with a +/- 0.0025" barrier tolerance calling out for example a 0.035/0.040" clearance. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a