next newest topic | next oldest topic |
Author | Topic: general extrusion information |
UWStudent Member Posts: 2 |
posted June 28, 2002 04:04 PM
Hi, I'm a Mechanical Engineering Student at the University of Waterloo in Ontario, Canada. I'm doing a project on plastic extrusion and blow moulding, specifically for pool covers. I'm looking for information on different plastic extruding and blow moulding processes, pros and cons of these processes, limitations, costs, machinery, and reliability. Any help in finding this information would be greatly appreciated. IP: Logged |
Steve H Moderator Posts: 386 |
posted July 02, 2002 03:06 PM
Can you be a little more specific, the size of pool, propeties the cover should have. Steve H IP: Logged |
UWStudent Member Posts: 2 |
posted July 02, 2002 10:18 PM
Thanks, but it's allright, the project is now over. I was just madly searching for info, but I ended up finding a text with everything I needed. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a