next newest topic | next oldest topic |
Author | Topic: Appropiate Screw |
fernando1000 Member Posts: 3 |
posted October 22, 2002 07:14 PM
Which would be an appropiate screw to avoid high temperatures using a soft PVC resin from Teknor Apex part # 02-U0223A-69NT IP: Logged |
Peter P Senior Member Posts: 61 |
posted October 23, 2002 04:00 AM
Fernando, The most suitable screw design depends on the rheological and thermal properties of your material. An inappropriate design can lead to excessive shear heating, which, of course, can be highly detrimental to your PVC, which is highly sensitive to temperature. To be sure that your screw design is satisfactory you need to undertake a screw design analysis based on one of the screw design packages available on the market. This will tell you whether or not excessive heat is being generated. Regards, Peter P IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a