UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw Trouble shooting in blown film extrusion
|
next newest topic | next oldest topic |
Author | Topic: Trouble shooting in blown film extrusion |
T.K.Palanisami Senior Member Posts: 26 |
posted November 28, 2002 04:59 AM
Can any one tell where I can find the best trouble shooting information about blown film extrusion. Regards T.K.Palanisami IP: Logged |
Steve H Moderator Posts: 386 |
posted November 29, 2002 01:23 PM
G'day TK Welcome to the forum, I prefer to use first names I've already given some ideas to your post at Plastics.com If you haven't checked out the co-ex delamination post here, I've listed some co-ex resources that you might find useful. Steve Hodgson IP: Logged |
BrianAndLiz Senior Member Posts: 42 |
posted November 29, 2002 03:06 PM
Any specific problem you're looking to solve? Or just general troubleshooting? IP: Logged |
T.K.Palanisami Senior Member Posts: 26 |
posted November 30, 2002 09:41 AM
Yes I have the bubble stability problem in the Lab extruder. When I use the COC,PE blends.. Can you help me Regards T.K.Palanisami IP: Logged |
Bob Cunningham Senior Member Posts: 115 |
posted December 07, 2002 06:01 PM
Here I thought that I'd been in the field of Blown Film for a long time, and thought I'd heard of most everything. But I have never heard of COC before! What is (a) COC? -Bob Cunningham IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a