UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw Configuration of stainless steel nip rolls
|
next newest topic | next oldest topic |
Author | Topic: Configuration of stainless steel nip rolls |
Ray Member Posts: 1 |
posted April 12, 2003 11:51 AM
I am seeking information on the configuration of stainless steel nip rolls used as downstream equipment on a thermoset compound extrusion line. Do you know if the inside of the rolls are honeycombed to allow chilled water to cool the surface of the rolls evenly? If so. Can you suggest an effective way to clean out the interior section of the rolls? Thank you, for any assistance you can provide regarding this matter. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a