UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw mass flow rate of an extruder screw
|
next newest topic | next oldest topic |
Author | Topic: mass flow rate of an extruder screw |
Aaron C Member Posts: 1 |
posted June 29, 2003 12:36 PM
I am trying to find out if the mass flow rate of a feedscrew increases linearly with increase in RPM. My supplied information says it should be linear, but my experimental data shows it to be second-order. I am using a 1/4" 8 pitch feed screw to transport 316L SS with a powder size distrobution from 180 to 45 microns. Please call if you need more information. Thanks! Aaron IP: Logged |
Bob Cunningham Senior Member Posts: 47 |
posted July 01, 2003 02:28 PM
Not linear. For grooved-feed extruders feeding pellets (not powder), you can get very close to linear. But not with a smooth bore or powder. -Bob Cunningham IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a