next newest topic | next oldest topic |
Author | Topic: Extrusion Info. |
Richard W Member Posts: 1 |
posted August 28, 2003 01:01 PM
I am presently working on a project that requires extrusion molding and know very little about it. I know the basic operation, but nothing about how and where to get dies made, how long the part has to be to cut it off, how you cut the part off, etc. can you guys guide me in the right direction? Thanks for your time, Rich IP: Logged |
zabielski Senior Member Posts: 227 |
posted August 29, 2003 08:00 AM
Contact http:/www.psro.usm.edu for their polymer and processing site called MACROGALLIA. IP: Logged |
Rujul Member Posts: 1 |
posted September 23, 2003 04:12 PM
Seems like you've got the wrong web site address: It should be http://www.psrc.usm.edu I went to the same school to earn my BS (Polymer Science) Regards, Rujul ------------------ IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a