Ask the experts! These processors and consultants have been there and done that. Post your enigma now!


UBBFriend: Email This Page to Someone!
   Plastic processing forums for extrusion information and advice and for other feed screw applications.
  Extrusion, Single Screw
  Barrel/Screw Measuring

Post New Topic  Post A Reply
profile | register | preferences | faq | search

next newest topic | next oldest topic
Author Topic:   Barrel/Screw Measuring
colbond1
Member

Posts: 1
From:enka, nc
Registered: Dec 2003

posted December 12, 2003 08:54 AM     Click Here to See the Profile for colbond1   Click Here to Email colbond1     Edit/Delete Message   Reply w/Quote
Can anyone out there recommend someone in the western North Carolina area for screw/barrel measuring? Sizes 3.5" to 6".

Thanks

IP: Logged

alpertl
Senior Member

Posts: 36
From:Fremont, CA USA
Registered: May 2002

posted December 17, 2003 03:40 PM     Click Here to See the Profile for alpertl   Click Here to Email alpertl     Edit/Delete Message   Reply w/Quote
quote:
Originally posted by colbond1:
Can anyone out there recommend someone in the western North Carolina area for screw/barrel measuring? Sizes 3.5" to 6".

Thanks

It is not too difficult to do yourself. I believe Spirex used to offer this service.

IP: Logged

todd
Member

Posts: 1
From:
Registered: Dec 2003

posted December 17, 2003 04:00 PM     Click Here to See the Profile for todd   Click Here to Email todd     Edit/Delete Message   Reply w/Quote
Flite Technology builds barrel inspection
equipment, flight mics and also does on-site inspections in that area.

800-327-9310

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Feed Screw Designs

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a