UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw Mixinf Screw for PLA and contact material
|
next newest topic | next oldest topic |
Author | Topic: Mixinf Screw for PLA and contact material |
samin Member Posts: 4 |
posted April 27, 2004 01:45 PM
We have extrusion application for PLA-high molecule. Since it is not as corrosive as FEP, I would like to know if 440C stn. stl. is suitable material for contact area. We can always spec out Inconel. As far as screw is concerned what is best mixing design? IP: Logged |
Tom C Moderator Posts: 321 |
posted April 27, 2004 03:42 PM
What are you going to mix, how much, how long is the extruder, single screw or twin screw, is there a vent? Tom C IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a