UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw Anyone Else Work on Uniloy 350R2's?
|
next newest topic | next oldest topic |
Author | Topic: Anyone Else Work on Uniloy 350R2's? |
C@tch22 Member Posts: 3 |
posted November 17, 2004 05:54 AM
I've actually been looking for some active forums relating to work for quite some time, but only now came across this place. I'm 30 years old and reside in North Carolina. I've only belted a net 6 years experience in Blow Mold extrusion, but there is something I genuinely love about my job. Just chat away with me, I guess. Talk problems/solutions. share pictures, etc. IP: Logged |
Steve H Moderator Posts: 327 |
posted November 17, 2004 12:35 PM
G'day David Welcome to the single screw forum. ------------------ If at first you don't succeed, skydiving is not for you. IP: Logged |
C@tch22 Member Posts: 3 |
posted November 17, 2004 04:01 PM
Thanks for the link, Steve. I've been into plastics for about 11 years, but not soley Blow Molding. I've done some thermoforming and adhesive lamination, also. I didn't get to know the adhesive lamination machines too well because the company was bought out from a Canadian source, and, generally, the plant was mal-run. Do you know if these are the most active forums on the 'net concerning Blow Mold - Extrusion? IP: Logged |
Steve H Moderator Posts: 327 |
posted November 18, 2004 02:27 PM
You could try the forums at www.plastics.com, SPE's message boards get a bit of traffic too. ------------------ If at first you don't succeed, skydiving is not for you. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a