next newest topic | next oldest topic |
Author | Topic: Die design software: Flow 2000 |
lily72ca Senior Member Posts: 9 |
posted January 10, 2005 03:14 PM
I am going to do profile die design. I am very new in die design (only took two die design course where I was in school). I am just wondering if someone has experience with Flow 2000. I sure found some good feedback about it. Because it is very expensive software, I really hope I could get some suggest from you, before I recommend it to my boss. We don't have many new products, so it may take very long to get it pay back..... Thank you IP: Logged |
Tom C Moderator Posts: 427 |
posted January 10, 2005 04:03 PM
Lily, Compuplast Canada can design the die for you, using the Flow2000 software, for a fee which is a lot less than the purchase price of the software. check them out at; I am the US representative for Compuplast. Tom Cunningham IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a