UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw Extrusion method and speed for FPVC tube/hose
|
next newest topic | next oldest topic |
Author | Topic: Extrusion method and speed for FPVC tube/hose |
lily72ca Senior Member Posts: 10 |
posted January 13, 2005 08:03 PM
I got a quota requirement. They ask for flexible PVC tubes with 4.61mm ID and 2.5mm thickness. They also require ID must be concentric with OD with 0.25mm. This is a very tiny tube. Is it possible to use compression air to control the pipe inner diameter? Is the vacuum size tank must? Have anyone tried extruding two or more tubes at the same time? I could not get any good idea about it. Please help, give me some suggestion. Thank you IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a