| next newest topic | next oldest topic |
| Author | Topic: Processing powders |
|
gbrown@kaf-techmail.com Senior Member Posts: 7 |
posted January 24, 2005 02:08 PM
   
Currently evaulating the cost benefit of purchasing PVC in powder form versus pelletized. Flexible, semi rigid, and rigid PVC. Equipment requirements for optimum output and quality. Is twin screw extrusion required even for the flexible material? Would a vented single screw extruder work? Any information or reference information would be apprectiated. ------------------ IP: Logged |
|
zabielski Senior Member Posts: 340 |
posted January 29, 2005 07:33 AM
Before you even start, why don't you first state your annual use. How many product codes do you have Benchmark's like these are needed. IP: Logged |
|
gbrown@kaf-techmail.com Senior Member Posts: 7 |
posted January 31, 2005 08:19 AM
Usuage is approxoximately 2 - 2.5 million pounds annually between 4 products. 70% would be flexible with 30 % rigid IP: Logged |
|
zabielski Senior Member Posts: 340 |
posted February 03, 2005 05:47 AM
I've sent you an E-mail, requesting you give me a call. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
  |
|
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
