next newest topic | next oldest topic |
Author | Topic: new machine |
pat Member Posts: 3 |
posted March 14, 2005 04:27 PM
Greetings all.I just found this forum through my searching for info on a new machine for my employer.Forum looks quite good...wish it..and comps, had been around 20 years ago when I was learning how to run all materials,all grades,all conditions on our original strand line set up.hope to visit often,and may be able to assist someone down the line. IP: Logged |
Steve H Moderator Posts: 351 |
posted March 15, 2005 12:59 AM
Howdy Pat Welcome aboard Steve IP: Logged |
louis33 Senior Member Posts: 111 |
posted March 15, 2005 05:53 AM
Mega Dittos And no - that does not mean I lean that way IP: Logged |
pat Member Posts: 3 |
posted March 21, 2005 11:30 PM
Hi fellas.Me again.(now responding from the workplace comp).A quick question.I filled out a quote request form on the home page of this forum about a week or so ago and have yet to hear anything.Am I simply being impatient or should Ijust re-submit.Any thoughts appreciated.Thanks Pat IP: Logged |
FSD Admin Administrator Posts: 109 |
posted March 25, 2005 09:05 PM
Please provide information about your request so I can track it down. Sorry for the delay. Thanks Ron Anderson IP: Logged |
pat Member Posts: 3 |
posted March 26, 2005 05:08 PM
Hi Ron.I just sent an updated quote request yesterday with the proper e-mail reply address(my mistake).To make a long story short,we're looking for a new,single screw,vented,6" machine .We recycle post consumer hdpe,re-pelletizing it for sale to various markets.Whem I found your site I thought, 'great'this could really help me narrow the field down.Any assistance you can pass on will be greatly appreciated.Thanks.By the way,nice site!.Pat Sheehy IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a