next newest topic | next oldest topic |
Author | Topic: HDPE v MDPE |
alanv Senior Member Posts: 9 |
posted May 11, 2005 05:12 PM
Would you suggest any marked change in temperature configuration when running HDPE against MDPE? Also in what way would the general extrusion properties differ, if any? IP: Logged |
Coronadrinker Member Posts: 3 |
posted May 12, 2005 08:57 PM
I would say it depends on your blend ratio. If your running 50HD:50LD then the temperature profiles could be in relation to either HD or LD. In our process when we run 60HD:40LD we run HD temperatures as the mass of Hd being used is greater. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a