next newest topic | next oldest topic |
Author | Topic: barrel wear |
gllemoine Senior Member Posts: 18 |
posted August 03, 2005 03:58 PM
Hi, I would like to know what is the acceotable wear on a extruder barrel for blown film. Thank you IP: Logged |
Tom C Moderator Posts: 564 |
posted August 03, 2005 04:12 PM
I generally consider a screw worn out when it is at or below 99.33% of the barrel's original ID. Use that as a guide for the barrel. Please contact me if you are interested in a barrel bore gauge. ------------------
Tom Cunningham
Extrusion Technical Services [This message has been edited by Tom C (edited August 03, 2005).] IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a