next newest topic | next oldest topic |
Author | Topic: orientation in extrusion |
Rei Member Posts: 3 |
posted September 17, 2005 07:45 PM
Is possible to produce biorientation in extrusion? What parameters should i adjust to achieve my goal? IP: Logged |
Steve H Moderator Posts: 372 |
posted September 18, 2005 06:17 PM
Hi Rei Welcome to the single screw forum, what extrusion process are you using? The amount of bubble inflation adds orientation in the transverse direction while hauloff adds it in the other. For cast film/sheet, you can only draw the material down to add orientation in the machine direction, to add it in the transverse direction the film needs to be heated and mechanically pulled in that direction. ------------------ If at first you don't succeed, skydiving is not for you. IP: Logged |
Rei Member Posts: 3 |
posted October 05, 2005 09:02 PM
Thank you so much, i asked about the cast/sheet extrusion. So, if i donīt pull the sheet i get any orientation. Thank you so much quote: IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a