next newest topic | next oldest topic |
Author | Topic: die design |
john Member Posts: 3 |
posted December 10, 2005 09:44 AM
for a santoprene 65A duro profile with .025 wall,the die should be 10%-15% bigger??thanks for the help. How do you say that in english ? is it drawdown or drawdawn for the die???Thanks for the help. IP: Logged |
Tom C Moderator Posts: 659 |
posted December 10, 2005 09:50 AM
The term is draw down ratio. Materials which are very stiff typically have low draw down ratios, 5%. Soft and rubbery materials tend to have higher draw down ratios. Low melt strength will increase draw downs which act against droop. These ratios tend to be derived from expereince. Once determined, they are fairly consistent. ------------------
Tom Cunningham
Extrusion Technical Services www.ExtrusionTechnicalServices.com IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a