next newest topic | next oldest topic |
Author | Topic: petg |
dano Member Posts: 2 |
posted December 29, 2005 04:46 PM
hi i am looking to extrude petg into pellet i have a single screw extruder with no venting is it possible to use this regards dano IP: Logged |
Stephen J. Derezinski Senior Member Posts: 7 |
posted January 03, 2006 10:26 PM
You can vent pet with a vented barrier screw. See www.extrudertech.com for information on vented barrier screws. IP: Logged |
dano Member Posts: 2 |
posted January 07, 2006 02:36 PM
mant thanks for reply i have looked at the site and see the difference in screw can be the difference between running with problems and running with out so i need to look at the extruder and get some info on changing over to this type of screw also read some of your intereting texts on this subject ps know anybody in uk that sells this type regards Dano IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a