UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Single Screw the control of single screw extruder
|
next newest topic | next oldest topic |
Author | Topic: the control of single screw extruder |
magnoo Senior Member Posts: 5 |
posted March 03, 2006 08:08 PM
i am on a project of manfacuring plastic extrusion machine , the machines i sawed controled by py programable logic control (plc) , i want to make the control by a microcontrol chip which contain analog to digital port and include comparator ..... , i want to know if the chip can used in the industr manfacturing and is it affected by elctro magantic waves of the drive motor and if i need to isolate the control circuit and the bower cicuit with the chip .. thx fo replaying ------------------ IP: Logged |
Tom C Moderator Posts: 689 |
posted March 04, 2006 09:58 AM
PLC suppliers have standards for power supply, isolation, shielding and grounding which, if followed, will give you good results. Tom C IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a