next newest topic | next oldest topic |
Author | Topic: Repro material usage low |
Casey H Member Posts: 3 |
posted May 08, 2006 01:01 PM
We typically run high repro content in some of our blends. We measure screw and barrel ware, and will change barrel and or screw to improve outputs (or both). But when the tolerances decrease the amount or repro I can put in the blends decreases. My total extruder output goes up as it should. What should I be looking for in a screw to keep both up? Thanks, IP: Logged |
the plastic surgeon Senior Member Posts: 6 |
posted May 08, 2006 01:37 PM
What are you melting and how high is a high amount of regrind? IP: Logged |
Casey H Member Posts: 3 |
posted May 08, 2006 02:06 PM
LDPE, Butene, Hexene, SHexend Any were from 10% to 65% IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a