next newest topic | next oldest topic |
Author | Topic: Film Extruder Design |
isrealdvd Member Posts: 1 |
posted June 17, 2006 04:35 AM
i am looking for all design information for film extruders to enable me to manfactuer these type of machines anybody please can help to get all these required information B.Regards IP: Logged |
Tom C Moderator Posts: 718 |
posted June 17, 2006 10:06 AM
The traditional method would be to work for a manufacturer of this equipment for 10 years, and then go out on your own. Another way is to become an assembler of equipment made by other manufacturers, and then slowly start designing and making the components yourself. By buying software and training from www.Compuplast.com you can eliminate decades of trial and error design work and get fast results using proven scientific and engineering principles. I represent Compuplast in the USA. ------------------ Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
Stephen J. Derezinski Senior Member Posts: 40 |
posted June 17, 2006 10:23 PM
The most successful machine designers that I know have decades of practical experience as a base. If you do not have that base, I do not think you have sound business plan. Good software is an essential, but I do not know of anybody making it on software alone. ------------------ IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a