Posts: 10
From:Mishmar Ha'Emek 19236 Israel
Registered: Aug 2002

posted September 10, 2007 08:54 AM            

---

I am looking for a machine to produce a film 2700mm wide, 80 microns (~3 mil) from PE, with good mechanical properties and
very important:
A layer of PSA (pressure sensitive adhesive, such as Kraton, Levamelt, VLDPE etc.) on one side.
The machine should be state of the art, full automatic control.
Coextrusion of 3 or more layers, with outside layers about 10% of the total.

Who can produce such a machine???
(I haven't specified cast or blown - any recommendations? Pros and cons?)

Thanks!

------------------
Yori
yoramc@tama.co.il

[This message has been edited by yori (edited September 10, 2007).]

IP: Logged

All times are ET (US)