next newest topic | next oldest topic |
Author | Topic: Die designer needed |
glen591 Member Posts: 2 |
posted May 26, 2008 10:23 AM
I am looking for a custom die design supplier for small wire EDM shop . I am located in Barrie, Onatrio, Canada. Any information would be greatly appreciated. You can reply my post or send me email: glen591@hotmail.com . Thank you IP: Logged |
Tom C Moderator Posts: 911 |
posted May 26, 2008 10:59 AM
Compuplast provides profile die design software. Some of the features are; Easy to use. If you can use any CAD software like Autocad and SolidWorks you can operate this software. The software can be set up to automatically balance the flow in a die design. Using the "Cross Flow Minimalization Method" developed by Compuplast, dies can be developed that operate at a range of output rates. Typically the number of recuts to tune the die are reduced from 10 or more, down to 3 or less. Sample Screen;
Extrusion Technical Services is a Compuplast representative.
Tom Cunningham [This message has been edited by Tom C (edited May 26, 2008).] IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a