next newest topic | next oldest topic |
Author | Topic: Cleaning TPU extrusion dies |
jgaver Senior Member Posts: 7 |
posted July 28, 2008 02:29 PM
We currently run our dies and spindles through a pottery kiln to bake off all residue that is on the tooling but we had a kiln stick and almost burn the place down. Does anyone have any suggestions on a better way to clean the tooling, or a suggestion as to where I can find a good solid kiln for this? It doesn't need to be big, the tooling is fairly small. Thanks for your time and help. IP: Logged |
Tom C Moderator Posts: 913 |
posted July 28, 2008 03:51 PM
Check out these guys who make a fluidized bed cleaning oven for this purpose; http://www.techneusa.com/tempcalibration/ifbbaths.htm ------------------ Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a