next newest topic | next oldest topic |
Author | Topic: PP DIE |
Antony Member Posts: 2 |
posted November 27, 2010 11:59 AM
Hello: I have a problem with the extrusion of PP Strap Band. We always extruder one strap at a time, but when we change to a die with two exits for two straps at the same time, the straps have different width, 2 mm difference, so we have clean the die, and give more temperature to the die side that the strap have less width, but nothing happens, still the same problem. Any Idea? Thank you Antony ------------------ IP: Logged |
Tom C Moderator Posts: 997 |
posted November 27, 2010 01:20 PM
Look for sources of imbalance. Heaters Extremely small differences in geometry from side to side, especially in narrow gaps, can cause imbalance. Tom C IP: Logged |
Antony Member Posts: 2 |
posted November 29, 2010 09:06 AM
I will check again all and I will test it again. Thank you very much IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a