Author
|
Topic: downstream equipment needed for 4 inch diameter pvc pipe
|
nathan weaver Junior Member
|
posted 03-14-2002 01:46 AM
I am a student looking to set up downstream equipment to run 4 inch diameter PVC pipe. I would like to know what equipment is needed. The size,cost,and features of this equipment would be greatly appriciated. thank youIP: Logged |
2beeps Junior Member
|
posted 04-15-2002 11:55 PM
Nathan, I could describe the downstream equipment to you in some detail (depending if you wanted vacuum sizing or pressure plug sizing)--off of a twin screw, or single screw extruder.However, a better approach for you would be to contact a major pipe extruder mfg., like Milacron in Cincinnati,American Maplan in Wichita, or Krauss Maffei in KY.,all of whom offer "turnkey pipe extrusion lines",and can send you literature on the cooling tanks,pullers,saws,and dump tables---along with any added belling apparatus needed. Skip IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|