Author
|
Topic: k-tron
|
ikoni Member Posts: 2 From:tr Registered: Apr 2005
|
posted April 07, 2005 04:58 AM
hello friendsnow i m using k-tron feeding system and have some problems with that unit system works like that it goes volimetric when refilling then turns to gravimetric when passing vol to grav the feeding goes up/down this causes unconstant torque if anybody give me information i will be very pleasant
IP: Logged |
Tom C Moderator Posts: 534 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted April 07, 2005 07:46 AM
Check for motor stability during the refill and transition to gravimentric.Lower the motor gain. Increase the time base. Check for "blow through" during refill. Check for refill device dribble after refill. ------------------ Best Regards, Tom Cunningham Extrusion Technical Services www.ExtrusionTechnicalServices.com IP: Logged |
ikoni Member Posts: 2 From:tr Registered: Apr 2005
|
posted April 07, 2005 09:53 AM
thanks tomregards [This message has been edited by ikoni (edited June 05, 2005).] [This message has been edited by ikoni (edited June 05, 2005).] [This message has been edited by ikoni (edited June 05, 2005).] IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|