Author
|
Topic: U-PVC / Black spots
|
Grandeporti Senior Member Posts: 6 From:Tradate, Italy Registered: Jul 2006
|
posted July 31, 2006 08:52 AM
Hello,we are experiencing problems with our co-kneader from Buss (MKS 200, screw length 2580mm, screw diameter 130mm, barrel diameter 200). We have black deposits growing on the screw flights just before the buffle ring. These black deposits are released from time to time. We are sure that this problem is not correlated to the formulation. It seems that the problem is correlated to output (this extruder is dimensioned for max output of 3 tons and we are running at 1.7 - 2.0 tons/h) cause at high output becomes stronger, but reducing to 1.3 - 1.5 tons/h will not solve it. heating/cooling devices are running properly. Do you have any experience? Any suggestion? Thank you in advance. regards
IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|