Author
|
Topic: how to trouble shoot HDPE
|
Rex Franklin Member Posts: 1 From:Crawfordsville In. USA Registered: Apr 2005
|
posted April 20, 2005 03:38 PM
I am looking for something to help me produce a better product in the line of sheet plastic. We run pp & pe at our company. I am a new operator and am looking for some help in learning how to best operate my lines.IP: Logged |
Tom C Moderator Posts: 501 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted April 20, 2005 05:15 PM
Rex,Are you interested in a consultant, on-site training, a seminar, a CD extrusion course, or a book? All of these items are available to support your process. ------------------ Best Regards,
Tom Cunningham Extrusion Technical Services www.ExtrusionTechnicalServices.com [This message has been edited by Tom C (edited April 20, 2005).] IP: Logged |
Steve H Moderator Posts: 353 From:New Zealand Registered: Jun 2001
|
posted April 21, 2005 06:17 AM
Hi rex Welcome to the Sheet forum. Locate the Makers and grade numbers of the resins you are running, do a "google" for those and pull up the makers tech sheets and extrusion guides, these make a great starting point. Dynisco publish a great little Extrusion Handbook, lots of useful info in that. The Society of Plastics Enginners is a good source of info too www.4spe.org chech out the bookstore and the extrusion division newsletterSteve IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|