UBBFriend: Email This Page to Someone!
   Plastic processing forums for extrusion information and advice and for other feed screw applications.
  Sheet
  Extruder gauge variation on sheet line

Post New Topic  Post A Reply
profile | register | preferences | faq | search

next newest topic | next oldest topic
Author Topic:   Extruder gauge variation on sheet line
Ray Gendron
Member

Posts: 1
From:Lowell, Ma
Registered: Dec 2005

posted December 06, 2005 08:44 PM     Click Here to See the Profile for Ray Gendron   Click Here to Email Ray Gendron     Edit/Delete Message   Reply w/Quote
Looking for help in trying to stabilize surging on a recently purchased 3.5 sheet line.

IP: Logged

Tom C
Moderator

Posts: 661
From:Brodheadsville, PA USA
Registered: Jun 2001

posted December 06, 2005 09:36 PM     Click Here to See the Profile for Tom C   Click Here to Email Tom C     Edit/Delete Message   Reply w/Quote
On-line or on-site help?

If on-line we need a lot more information.

------------------
Best Regards,

Tom Cunningham

Extrusion Technical Services

www.ExtrusionTechnicalServices.com

IP: Logged

the plastic surgeon
Member

Posts: 2
From:Dover, OH USA
Registered: Nov 2005

posted December 12, 2005 01:40 PM     Click Here to See the Profile for the plastic surgeon     Edit/Delete Message   Reply w/Quote
with no info i would guess look at your feed section or perhaps any regrind variation in % or particle size.

is the surging cyclical? how long of cycle?

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | Feed Screw Designs

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a