Author
|
Topic: draw-down ratio
|
shawn8791 Senior Member Posts: 9 From:brazil, IN, USA Registered: Oct 2006
|
posted February 01, 2008 12:29 AM
Does anyone have suggestions for draw-down ratios for small dia (.125-1") fpvc and ldpe tubing?Thanks for any help. IP: Logged |
Tom C Moderator Posts: 903 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted February 01, 2008 10:21 AM
I believe each polymer has an ideal draw down range dependent on melt strength, swell and resistance to elongation. The supplier may be the best source of information.Some information here; http://www.spe-ggs.org/spe/html/tech_topics/extrusion/draw_down_ratio.html http://www.plasticextrusiondata.com/PDF_files/28103_14.pdf ------------------ Best Regards, Tom Cunningham www.ExtrusionTechnicalServices.com IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|