Author
|
Topic: pipe production
|
layeeq Member Posts: 3 From:hydrabad Registered: Dec 2004
|
posted February 09, 2005 04:54 PM
hi i want some formulation for pvc pipe production with low cost give chemical additives information thanks LayeeqIP: Logged |
PAWAN POLYMERS Senior Member Posts: 5 From:MUMBAI,MAHARASHTRA,INDIA Registered: May 2005
|
posted May 28, 2005 02:16 AM
PVC HP K-65 100 PARTS MERCAPTOESTER STABILIZER 0.5 PARTS CAL.STEARATE 0.5 PARTS PARAFFIN WAX 1.2 PARTS PE WAX 0.25 PARTS Tio2 1.0 PARTS CaCO3 3 PARTS THIS IS BASIC PIPE FORMULATION BLENDED AS A DRYBEND MIXIP: Logged |
lianis Senior Member Posts: 15 From: Registered: May 2005
|
posted June 02, 2005 09:12 AM
test 3IP: Logged |
2beeps Moderator Posts: 98 From:Silver City, NM, USA Registered: Jun 2001
|
posted June 04, 2005 08:59 PM
Pawan has given you a very good starting point formulation for TWIN SCREW pipe extrusion----after some running history, you may be able to reduce tin stabilizer to 0.4phr. As Pawan said, this is a dryblend powdered compound made in a high intensity mixer---blended to 120C.IP: Logged |
mwnuts Member Posts: 3 From:Blantyre, Malawi Registered: Jul 2005
|
posted July 27, 2005 03:03 AM
Hi,Can you advise regarding a mPVC formulation ? Kind regards, Bilal IP: Logged |
2beeps Moderator Posts: 98 From:Silver City, NM, USA Registered: Jun 2001
|
posted July 27, 2005 10:56 AM
See reply in Twin Screw forum----Same formulation will work for m-PVC--recognizing a higher bulk density powder mix is obtained with m-PVC, and extrusion running conditions need adjusting vs.s-PVC compounds. IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|