Fluoro Elastomers - Plastic processing forums for extrusion information and advice and for other feed screw applications.

UBBFriend: Email This Page to Someone!

Plastic processing forums for extrusion information and advice and for other feed screw applications.

Extrusion Wire and Cable

Fluoro Elastomers

profile | register | preferences | faq | search

next newest topic | next oldest topic

Author

Topic: Fluoro Elastomers

polymerguy
Senior Member

Posts: 6
From:germany
Registered: Nov 2006

posted November 22, 2006 12:17 AM

Hi Everybody,

We have extruded FKM but unfortunately we face some pickles in the surface of the extruded rubber. now we need to get rid of the defect. we are using a 50 mm extruder and the pressure we see is very high ( 600 bar)

can you tell me some suggestions to get rid of the defects.

Thanks in advance....

IP: Logged

Tom C
Moderator

Posts: 792
From:Brodheadsville, PA USA
Registered: Jun 2001

posted November 22, 2006 10:31 AM

Was this not already asked, answered and resolved?

------------------
Best Regards,

Tom Cunningham

www.ExtrusionTechnicalServices.com

IP: Logged

All times are ET (US)	next newest topic \| next oldest topic
Administrative Options: Close Topic \| Archive/Move \| Delete Topic
	Hop to:

Contact Us | Feed Screw Designs