UBBFriend: Email This Page to Someone!

Feed Screw Designs Forums   Fluoropolymer   Wire & Cable Extrusion dies    profile | register | preferences | faq | search

Author	Topic:   Wire & Cable Extrusion dies
jorgewegbrait Junior Member	posted 11-29-2001 07:03 AM             I am looking for information on basic design principles for corssheads and dies for extrusion of wires and cables for different materials: PVC, PE (HDPE & LDPE), XLPE, etc. Any idea where I can find information? Thank you IP: Logged
Ron Anderson Junior Member	posted 11-30-2001 01:36 PM                You may want to check into these guys, http://bhtool.com/ IP: Logged

All times are ET (US)	next newest topic | next oldest topic
Administrative Options: Close Topic | Archive/Move | Delete Topic
	Hop to: Select a Forum List of Forums: Category: General Conversations --------------------Mrs.Robinson's Retreat Category: Processing Specific --------------------Extrusion, Single ScrewExtrusion, Twin ScrewInjection Molding, ThermoplasticInjection Molding, Thermoset Blow Molding, InjectionBlow Molding, ExtrusionCompounding, GeneralCompounding, Single ScrewCompounding, Segmented Twin ScrewsCompounding, Solid Twin Screws Category: Product Specific --------------------PVC ProductsSheetProfileFilm and BagExtrusion CoatingsExtrusion Wire and CableMulti & MonofilamentsFluoropolymerEpoxyAutomotiveMedical

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a