Author
|
Topic: Fluoropolymer ready micro-extruder
|
Tom C Moderator Posts: 578 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted September 23, 2003 08:58 PM
This is Gimac's 14MM Mico-Extruder specifically designed to run low rate fluoropolymers. Maximim rate is about 7lbs/hr. Minimum rate is in the 100 grams/hour range. A PDF of the above is available at this link: http://www.feedscrews.com/viewnews.php?id=181 Tom Cunningham Extrusion Technical Services
[This message has been edited by Tom C (edited September 23, 2003).] IP: Logged |
charliehagee Senior Member Posts: 13 From:Scranton, PA Registered: Sep 2003
|
posted September 24, 2003 09:16 AM
You can also find USA built FEP extruders in the same size range at www.waynemachine.com
IP: Logged |
simone Member Posts: 1 From: Registered: Aug 2005
|
posted August 22, 2005 11:09 PM
Mmmmmm.... The machine that you are speaking about is not working... about Gimac I can run from 0,2 cubIn/hour to 91 cubIn/hour of PEEK FEP Biopolymers or anything else...IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|