next newest topic | next oldest topic |
Author | Topic: extruded film path |
goulmik Member Posts: 2 |
posted May 16, 2003 08:41 AM
hi, i'm looking for efficient solutions to guide my film from the extruder output to the next machine. thanks IP: Logged |
zabielski Senior Member Posts: 146 |
posted May 17, 2003 07:39 AM
There are a variety of grooved roller manufacturer's out there, but i recal once using simple 1" wide masking tape. I wound it from each edge (live a "V" towards the center from each end, and it worked fine. If and when you aquire a real grooved design, insist on a gauranty that it works - period. Chicago Poller is a place to start. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a