UBBFriend: Email This Page to Someone! |
Plastic processing forums for extrusion information and advice and for other feed screw applications.
Extrusion, Twin Screw Twin Screw extrusion of NYLON in a multi-strand die
|
next newest topic | next oldest topic |
Author | Topic: Twin Screw extrusion of NYLON in a multi-strand die |
zabielski Senior Member Posts: 156 |
posted May 23, 2003 07:04 AM
I'm looking specificaly for design information on the die to prevent or reduce die drool build up. I would think that a special die has to be used, one with a tapered set of holes inward, and a reverse taper on the outer hole. Sure wish I can put this one to bed. The spit off causes all sorts of problems. IP: Logged |
Tom C Moderator Posts: 142 |
posted May 23, 2003 08:34 AM
Ken, An all time un-favorite problem. You need to address the material and/or process problem that is sourcing or causing a lot of low molecular weight components to be present at the exit of the die. I have some remedies that address symptoms, but in the material lives the cure. Email me direct with more information and I might be able to help. Tom C IP: Logged |
zabielski Senior Member Posts: 156 |
posted May 24, 2003 09:19 AM
Thanks Tom C., and I agree with you and will look into the materials used very closely. Of course it is a proprietary allloy, so I can't divulge it with all due respect. I appreciate your offer though. IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a