next newest topic | next oldest topic |
Author | Topic: LDPE Foam extrusion |
malikengg Senior Member Posts: 21 |
posted June 01, 2005 12:40 PM
To all concerned experts: I have a twin screw extruder with counter rotating screws 75mm diam. screws with post extrusion equipment like cooling-sizing mandrel and winder, high pressure plunger metering pump for injecting liquid carbon dioxide gas into the melted polymer while extrusion. Can I use the machine for producing low density foams with density of 0.02-0.025 g/cc used as protective packing sheet. Thickness of sheet range from 1mm (min.) to 4mm (max.) in standard width of 1.5 metres.
IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a