next newest topic | next oldest topic |
Author | Topic: Looking for some feedback |
smcdowe Member Posts: 2 |
posted January 11, 2006 08:37 AM
Good morning all, The company I am working for is looking into getting some interactive training. We deal with single and twin screw conical extrusion machines, Davis Standard and Cincy-Milacron. Somewhere on this forum I found thread that concenrend people looking for training software, the individual was looking for a cheaper alternative to Paulsons Training (As are we) and was directed to the SPE website. What I found there http://www.4spe.org/training/products/0170.php was this interactive training software from Raunwendaal. I was wondering if anyone has purchased this software and can give me your opinion or suggest other Software suite's that you favor. Thank you for your time in advance! Steve McDowell IP: Logged |
the plastic surgeon Member Posts: 3 |
posted January 13, 2006 12:29 PM
never used the Rauwendaal software but i have attended a seminar of his. great teacher. i imagine his software is equally impressive. IP: Logged |
smcdowe Member Posts: 2 |
posted January 13, 2006 03:20 PM
Thank you, that helps me out a bit. I have to contact the company maybe in order to get some testimonials or some of their customer feedback. Thank you again for your help! Steve McDowell IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a