| next newest topic | next oldest topic |
| Author | Topic: Running ABS pellet for profiles |
|
Jon B Member Posts: 1 |
posted February 28, 2007 08:42 AM
  
Does anyone have any experience with running ABS pellet material on a Twin Screw extruder for profiles? We have a CM-55 (55mm) conical screw extruder, with PVC screws in it, will that work? Do we have to dry the material or can we pull the moisture out thru the vent? Any information would be helpful IP: Logged |
All times are ET (US) | next newest topic | next oldest topic |
  |
|
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
