Author
|
Topic: FEP Extrusion
|
darylamykris Member Posts: 1 From:Palm Harbor, FL USA Registered: May 2004
|
posted May 02, 2004 05:06 PM
I am looking for information on extruding FEP for medical tubing, heat paramaters, screw speed, draw downs for tips and dies, or any books would be greatly appreciated. Thank you DarylIP: Logged |
Tom C Moderator Posts: 325 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted May 02, 2004 08:38 PM
Check out the Technical Wizard at: http://www.daikin.cc/ In addition I can put you in contact with a Daikin technical support engineer with extrusion expertise, if required. Tom C
IP: Logged |
louis33 Senior Member Posts: 81 From:Allentown, PA - USA Registered: Jun 2001
|
posted May 03, 2004 06:39 AM
Are you looking for "straight" FEP or a filled version? Tooling issues are pretty straight forward if you read the info from DuPont. Not sure if it is still available on their web site or not.Sizing is another story. Let us know. IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|