Author
|
Topic: used feedscrews
|
dgrunb Member Posts: 4 From:Montreal, Quebec, Canada Registered: Aug 2009
|
posted August 24, 2009 01:44 PM
I have about 14 old feedscrews which we no longer use, most are 3 1/2" and 4 1/2" If anyone has interest please let me know.Thank you David Grunberger Federal Plastics david@fedplast.com IP: Logged |
Tom C Moderator Posts: 964 From:Brodheadsville, PA USA Registered: Jun 2001
|
posted August 24, 2009 01:54 PM
Could you list by maker, diameter, L:D and style? (Vented etc.) ------------------ Best Regards,
Tom Cunningham www.ExtrusionTechnicalServices.com [This message has been edited by Tom C (edited August 24, 2009).] IP: Logged |
dgrunb Member Posts: 4 From:Montreal, Quebec, Canada Registered: Aug 2009
|
posted August 24, 2009 02:52 PM
we have about 7 - 9 screws which are 4 1/2" and the length of the areas not icluding the shank (flight sections only) are about 122" long. Probobly most are Davis Standard Style Shanks.We also have 3 -5 screws which are 3.5" and the length of the areas not icluding the shank (flight sections only) are about 100" long. Probobly most are Prodex or Sterling Style Shanks. Please advise interest or make me an offer. Thank you David IP: Logged |
Makeit Work Senior Member Posts: 9 From:USA Registered: May 2008
|
posted October 14, 2009 04:47 PM
TestIP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|