Author
|
Topic: HDPE recycling screw design
|
Anonoymous548 Junior Member
|
posted 10-23-2002 11:50 AM
This posting was done anonymously, the poster is known to FSD administration and will be provided to any interested parties as approbate.RE: Recycling HDPE bags by extrusion , extrusion Simulator I'm a last year student at the chemical engineering faculty, my thesis is about the recycling of HDPE extrusion, at this moment i'm working with a simulator, but i need te physical sizes of the screw to run it correctly (meter length, meter depth, flight lead, flight clearance and flight width) assuming a 1/30 and 40mm screw. I would appreciate very much for any information you can give me. > Material: Polyethylene, High Density (HD) > Process: Extrusion > Dimensions: 40mm-30:1
IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|