Author
|
Topic: Questions regarding feed-extrusion
|
saygin Member Posts: 2 From:MA. USA Registered: May 2003
|
posted May 11, 2003 06:30 PM
Hello, I am Saygin Celen, and a mech. eng. master's student in the Univ. of Mass. I'd like to ask a couple of questions, which are about my thesis. 1- What kind of apparatus (vapor and watering) is needed in the 1st, 2nd, and 4th sectios/units of the extruder to give the required shape to the product after the head, and how are these found?2- What is the ideal rotation of the extruder shaft?( meaning what is the proportion of the shaft revolving to the capacity and the hp of the motor?) 3- What is the use of the vacuum pump that is assembled to the last section of the barrel, and which should be used for the various capacities? Thank you.. IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|