|
Author
|
Topic: Troubleshooting Defects seminar
|
Robert Digiantonio
Junior Member
|
posted 07-30-2002 03:03 PM
   
This one-day training seminar will show how to identify injection molding defects and address them efficiently. It provides an understanding of why a defect occurs and how to correct it. Troubleshooting tips are given to reduce scrap in day-to-day operations and utilization of machine controls to minimize rejects. Hands-on attention is provided at this first-class facility, and you are encouraged to bring problem or challenging parts from your company. Attendees are awarded 0.6 CEUs and will receive a handbook containing all information covered in class.The outline for this course is:
- Review of Machines and Controls
- Identification of Defects
- Where Injection Defects Occur
- Tools for Troubleshooting
- How to Troubleshoot
- Correcting Molding Defects A special offering will be presented at the Hudson, Ohio Holiday Inn on October 24 and December 6, 2002, and in St. Augustine, Florida on October 11, 2002 Cost $329 Visit us at: www.plastics101.com
for additional information [This message has been edited by Robert Digiantonio (edited 07-30-2002).] [This message has been edited by Robert Digiantonio (edited 07-30-2002).] IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
|
