Author
|
Topic: Injection Molding Thermoplastics
|
rkdaga Junior Member Posts: 1 From:India Registered: Oct 2001
|
posted September 29, 2002 04:33 AM
What will happen if hopper side temperature is not controlled ?IP: Logged |
T.K.Palanisami Member Posts: 5 From:Aalen, Germany Registered: Nov 2002
|
posted November 30, 2002 09:47 AM
If the hopper side temperature is not controlled. The feeding section ie near to the hopper hole( the bottom side of the hopper) get hot and melt the plastic granuels in the hopper and block the feeding. So it is must to have the hopper cooling near the hopper in the feed section.If you don't cool the hopper you will have the feedíng problem.. Reagrds T.K.Palanisami IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
Ask the experts! These processors and consultants have been there and done that. Post your enigma now! |