Posts: 1
From:CA, USA
Registered: Jan 2003

posted January 29, 2003 10:37 AM               

---

Hi. I am a senior mechanical engineering student and for my senoir project I was assigned to design a toggle clamp for an injection compression press. Could you please send me some information on how to design a toggle clamp or where i could obtain this information.
> Thank You for your time and consideration.

IP: Logged

Posts: 86
From:McHenry, IL USA
Registered: Nov 2002

posted January 30, 2003 07:22 AM               

---

Glo: The easiest (and fastest thing is to find a molder, then ask them to allow you to study his machine. Ingenius designs are harnessed from preceeding designs.

IP: Logged

All times are ET (US)