Posts: 24
From:Aalen, Germany
Registered: Nov 2002

posted June 24, 2003 07:27 AM               

---

Recently I read an article about the water injection molding used
to make glass filled polyamide parts. I couldt understand water
and polyamide are two different things, water must be removed
during polyamide molding. But I dont understand how water is
used to mold nylon parts and if any one aware of this please let
me know what is advantage of water than gas?

IP: Logged

Posts: 1
From:
Registered: Jun 2003

posted June 24, 2003 07:31 AM               

---

I have seen in www.polymerlinks.com a good discussion is going on about water injection molding of polyamides you can just click the following link it will take you to the discussion topic ( water injection molding)
http://www.polymerlinks.com/discussion_topic_list.php?id=1

With Best Regards

IP: Logged

All times are ET (US)