Author
|
Topic: Injection Unit Retracts
|
juan Member Posts: 1 From:hermosillo, sonora, mexico Registered: Mar 2006
|
posted March 08, 2006 12:15 AM
Hi, I have a problem with a milacron machine..Some times, when the injection unit reachs the transfer position, it make a .500" retraction and then it continues with the hold and pack steps..I am trying to figure out what could cause it with out succes..What I have seeing, is this retraction is made due the controller is telling by a binary signal to the valve to made this movment, so, with this , I am discarting a bad funtion of the PDI valve..Does any one could help me to figure out the root cause ?? Thanks....
IP: Logged |
Contact Us | Feed Screw Designs
Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45a
Ask the experts! These processors and consultants have been there and done that. Post your enigma now! |